The procedure for installing a Jacuzzi tub can be a little involved. Therefore, it is best to prepare everything before you get to work.
Required Tools and Materials
Jacuzzi bathtub
Caulk
Tile and grout
Sheetrock
Paint
Level
Cleaning utilities
2 x 4s
Nails
Flatten the Surface
The flooring must be level. If it isn’t the tub’s jets won’t work properly. You’ll also have some problems with the water draining. Make sure that the surface can carry a weight of 150 lbs for every sq ft. Add some support if this weight can’t be sustained.
Support and Spacing
The tub needs to have full support at the bottom section. The support must also extend to the rim. Before installing a Jacuzzi tub, make sure the access panel measures 18” x 18 “.
This is essential so you can get to the motor. This also allows for sufficient ventilation. As you go through the design process, go over the access panel thoroughly.
Setting up the Jacuzzi
Use the level to ascertain the tub is flat. Check the front, back and the sides. Apply some shims if needed to balance it. Fasten the Jacuzzi along the framework and on the sheetrock.
The next step is to connect the wiring and plumbing. Follow the instructions carefully. If you make a mistake, the warranty will become null and void. Start off by grounding the tub. This is to prevent shocks.
Now get the terminal compartment box before you continue installing a Jacuzzi tub. There should also be a manual for putting the wires in place. Follow the directions on the diagram.
Note: this process can be quite complicated. Hire a professional electrician if you have any doubts about handling wires and power chords.
Cleaning and Finishing Up
When installation is finished, check all the electrical connections. Double check all the fittings to make sure they’re secure. Sweep the floor of any debris. Remove all the tools, nails and other paraphernalia.
Fill the Jacuzzi with enough water to go past the jets. Survey the tub for any leaks and drippings. Open the jets. After installing a Jacuzzi tub, allow the tub to run for 15 minutes at least.
Refer to the manual if there are any problems. If you followed the directions though, everything should work out just right.
Put sheetrock around the framework. You can paint or put some tile around the sheetrock too. If you use paint, allow at least 24 hours for it to dry. If you’re going to use tiles,
make certain the floor can carry the weight. Add more support if needed. Use the caulk gun to fortify the edges and prevent water from seeping through.
Warnings
Be very careful when making adjustments with the wiring. Do not attempt to modify the electrical settings when the tub is filled with water. The resulting electrical shock can kill you.
When you’ve finished installing a Jacuzzi tub and testing, it’s time to relax. Get in the tub, unwind and congratulate yourself for a job well done.
